corvair
Moderators: John Dean, Moderator
Re: corvair
Hi Mark,
Can't claim to be running a Corvair yet, but I've been building a Pietenpol with one fitted for many years!
There have been issues in the past with crankshaft failures, but you can buy fifth main bearing kits and even a 'billet' crankshaft from the USA, which seem to have solved the problem.
It would be worth checking with Engineering before going too far planning to use one in anything other than a Pietenpol, just in case they are not keen?
Cheers.
Can't claim to be running a Corvair yet, but I've been building a Pietenpol with one fitted for many years!
There have been issues in the past with crankshaft failures, but you can buy fifth main bearing kits and even a 'billet' crankshaft from the USA, which seem to have solved the problem.
It would be worth checking with Engineering before going too far planning to use one in anything other than a Pietenpol, just in case they are not keen?
Cheers.
Steve Bryan
028417
028417
-
- Posts: 456
- Joined: Wed Jan 02, 2008 11:00 am
- Location: Oxford
- Contact:
Re: corvair
There was an article in the LAA mag a couple of (or more) years back about someone running a Corvair -- I'm afraid I can't remember more than that, though presumably, as Steve suggests, Engineering should have relevant information.
If you look under "Corvair" on the Panther site, there is information about the fifth main bearing and billet crankshaft:
https://flywithspa.com/
If you look under "Corvair" on the Panther site, there is information about the fifth main bearing and billet crankshaft:
https://flywithspa.com/