Valve Compressor Tip
Posted: Sat Jun 19, 2010 1:10 pm
Putting some valves back into an O-200 last week - no helper. Also, no compressor 
Bit of headscratching came up with this
Check the size of the crowfoot - make sure everything is solid, lower the drill, lock it off and you can position the collets with ease.
Only snag was a little movement of the crowfoot causing a slight angle - I will make a Mk 2 next with a cheapo crowfoot epoxied into a shaft.
Bit of headscratching came up with this
Check the size of the crowfoot - make sure everything is solid, lower the drill, lock it off and you can position the collets with ease.
Only snag was a little movement of the crowfoot causing a slight angle - I will make a Mk 2 next with a cheapo crowfoot epoxied into a shaft.