Clevis Pins
Moderators: John Dean, Moderator
-
- Posts: 11
- Joined: Sat May 29, 2010 2:10 pm
Clevis Pins
My Tipsy Nipper has just been through its permit and has had an 'advisery' to ream/drill out the control surface hinges and replace the 3/16" dia clevis pins with 5mm dia pins. Does anybody know where I might source some 5mm pins of an equivalent material to the originals? I've tried to look up the reference given in the Mk2 Owners manual (i.e. SP/4Z/B14-0 3/16") but I've drawn a blank.
036802
http://tasmanindustries.co.uk might be able to help.
-
- Posts: 57
- Joined: Sat Jan 10, 2009 10:30 pm
"Rather than ream out to the metric size, I'd recommend the SP4Y, Cadmium plated pins instead."
Agreed - I have play in a Nipper which was picked up at Permit a little while ago. My inspector has instructed me to ream out to accept 7/32" SP4Y pins from LAS Aero.
Be aware that you'll need a narrow headed drill if you intend to ream in-situ as the hinges are very close to the wing and a conventional chuck will not allow you to drill parallel holes!
Agreed - I have play in a Nipper which was picked up at Permit a little while ago. My inspector has instructed me to ream out to accept 7/32" SP4Y pins from LAS Aero.
Be aware that you'll need a narrow headed drill if you intend to ream in-situ as the hinges are very close to the wing and a conventional chuck will not allow you to drill parallel holes!
regards
Gary Taylor
Gary Taylor
-
- Posts: 11
- Joined: Sat May 29, 2010 2:10 pm