Page 1 of 1
Molex Connectors
Posted: Fri Nov 11, 2011 10:59 pm
by Kittyhawk
Doe anyone know of a source of crimp on terminals to go in the black Molex connector at the back of a Narco radio mounting tray?
Roger
narco fittings.
Posted: Fri Nov 11, 2011 11:46 pm
by G.Dawes
Adams had some but they are about £2.00 each one. I nearly fell through the floor they are made at Whitstable along the road from me and then exported to the US then bought back. at twenty time the cost.
Posted: Sat Nov 12, 2011 8:23 am
by JohnLindsay
You could try Farnell Electronics. Their website lists a truly bewildering selection of Molex connectors plus related bits and pieces.
Posted: Sat Nov 12, 2011 8:26 pm
by Gavin Bell
there are different terminals for the radio and transponders. Same style but slightly different style.
I bought some for my radio on special order from RS. I i will try to find the part reference. I have it in work.
How many do you need?
Gavin
Posted: Sat Nov 12, 2011 8:38 pm
by Gavin Bell
I can't attach the file, but this link should take you to the Molex data sheet.
http://www.molex.com/pdm_docs/ps/PS-09-50.pdf
http://www.molex.com/pdm_docs/sd/008050302_sd.pdf
The part number is 0008050302
Advise go on the Molex site, download the part drawing and carefully check the physical dimensions against an existing terminal, as the ones for transponder and radio are very similar in size.
Once you have confirmed the part number you can search RS Components site, but as said before these are a special order with I believe a minimum charge of £10.
The problem I found was finding the right Molex part number.
Hope this at least points you in the right direction.
Regards
Gavin