TUBULAR FERRULES IN STEEL PLATES "TOOLING"?
Posted: Sat Jan 15, 2022 11:43 am
Hi
I'm looking for advice on the best way to fit tubular ferrules into holes in steel plates, and suggestions for suitable tooling "punches/press tool design".
It's for the various fuselage etc fittings where the hard bracing "piano wire" is attached through holes in the plates etc on a Sopwith Snipe repro.
Any advice would be appreciated.
Cheer's
Bob.
I'm looking for advice on the best way to fit tubular ferrules into holes in steel plates, and suggestions for suitable tooling "punches/press tool design".
It's for the various fuselage etc fittings where the hard bracing "piano wire" is attached through holes in the plates etc on a Sopwith Snipe repro.
Any advice would be appreciated.
Cheer's
Bob.