Can anyone help with advice on a source of thrust washers for a well used A-65, with a crankshaft that has been taken down to - 20 thou.
During a re-building session the other night, we discovered that our new washers ( regret I don't have the part number right now ) were clearly the wrong profile and were unsuitable. All the commonly available types of washer of which we are aware seem to have the wrong "flange"/ profile or cross section to fit properly against the bevelled edges of the front bearing housing in the crankcase. The type we need has a small pin that locates in a cavity to prevent rotation of the washers, but would sit snugly against the face of the housing and locate against the bevelled edge.
Any suggestions would be very welcome!
Continental A-65 - Thrust washers?
Moderators: John Dean, Moderator
-
- Posts: 45
- Joined: Mon Feb 04, 2008 7:27 pm
- Location: hampshire
a65 thrust
use
A36074 and A36075 times two
A36074 and A36075 times two