Warco Magnum Bender
Moderators: John Dean, Moderator
- Pete Turton
- Posts: 8
- Joined: Thu Oct 21, 2010 10:33 am
Warco Magnum Bender
Willing to pay a good price for an example in good condition - not bothered if metric or imperial bending bars are included. Maybe your project is complete and you no longer require them?? Thanks
-
- Posts: 3
- Joined: Thu Sep 17, 2009 1:31 pm
Re: Warco Magnum Bender
I have one of these I no longer need, it has had very little use. Please contact me off list on [email protected] to discuss.
Richard Pybus
023699
023699
-
- Posts: 213
- Joined: Wed Jan 02, 2008 7:06 pm
- Location: East Midlands
Re: Warco Magnum Bender
I have also been very keen to obtain this piece of equipment so if there is anyone else who no longer has a use for theirs then do please send me a PM !
Richard
- Pete Turton
- Posts: 8
- Joined: Thu Oct 21, 2010 10:33 am
Re: Warco Magnum Bender
Please PM me if you have one of these to sell. Please do not put a response here. I missed the one Richard P was selling. So I am still looking for one.
Re: Warco Magnum Bender
Perhaps one or two of these could be added to the LAA's collection of 'communal' tools for loan that I have heard exists but have no real knowledge of? I seem to remember that the previous NC Chairman was looking for a volunteer to look after the tools but not sure what there is or how it may be accessed.
regards,
Colin
regards,
Colin
018841
Colin Cheese
Colin Cheese