The place to raise issues, ask questions, swap ideas and discuss anything related to aircraft engineering, maintenance and building.
NB Any opinions expressed in this forum are not necessarily those of LAA Engineering
Moderators: John Dean, Moderator
-
Jonathan Wilkins
- Posts: 62
- Joined: Wed Feb 06, 2008 9:55 pm
- Location: Ashford Kent
-
Contact:
Post
by Jonathan Wilkins » Tue Feb 19, 2008 9:54 pm
Im still seeking a spinner with backplate for my Turb. Does anybody have one kicking around the garage/workshop/hangar that needs a home.
The backplate needs 6 holes 50mm apart. The spinner needs to fit a small 2 blade prop and be around 200mm in length. Probably a microlite or Eurostar type??
-
Phil Burgess
- Posts: 57
- Joined: Fri Jan 11, 2008 5:04 pm
- Location: Lincolnshire
Post
by Phil Burgess » Tue Feb 19, 2008 11:19 pm
I have a dome type spinner available if that would suit... It is for a VW engine and is the type that sits within the edges of the prop boss and is about 6 inches in diameter. Probably about 6 or 7 inches long, chrome finnish. Appears to be unused.
-
Jonathan Wilkins
- Posts: 62
- Joined: Wed Feb 06, 2008 9:55 pm
- Location: Ashford Kent
-
Contact:
Post
by Jonathan Wilkins » Wed Feb 20, 2008 8:22 pm
Thanks Phil but im looking for a full spinner, just to give the nose a slightly sleek finish......very un-Turb like i know.
-
Rob Swain
- Posts: 393
- Joined: Tue Jan 08, 2008 2:11 pm
Post
by Rob Swain » Fri Feb 22, 2008 3:50 pm
Phil, that dome one still available? I've mislaid the one for my VP1 project, and it was a bit moth eaten anyway.
Rob Swain
If the good Lord had intended man to fly, He would have given him more money.