Hello
If anybody has a Jabiru engined Nipper, would you mind sending me some pictures of the Throttle arrangement?
Thanks
John
Jabiru engined Nipper, Throttle arrangement.
Moderators: John Dean, Moderator
-
- Posts: 11
- Joined: Sat May 29, 2010 2:10 pm
-
- Posts: 3
- Joined: Mon May 05, 2014 11:58 am
Re: Jabiru engined Nipper, Throttle arrangement.
John
I have not got any pictures but can try to explain how it is set up.
We used a throttle lever in cockpit with a cable clamped within a pivot bolt. The cable outer was clamped onto the airframe. Jabiru used to supply a fitting for the carb lever. Make sure that the outer is well clamped and lock wired at the carb.
A source of cable can be motorcycle shops or marine suppliers.
You can also use a Teleflex control cable with a 1032 rod end bearing at the cabin end and cut the outer / inner to suit length required as I did.
I hope this helps.
Regards
Kevin
I have not got any pictures but can try to explain how it is set up.
We used a throttle lever in cockpit with a cable clamped within a pivot bolt. The cable outer was clamped onto the airframe. Jabiru used to supply a fitting for the carb lever. Make sure that the outer is well clamped and lock wired at the carb.
A source of cable can be motorcycle shops or marine suppliers.
You can also use a Teleflex control cable with a 1032 rod end bearing at the cabin end and cut the outer / inner to suit length required as I did.
I hope this helps.
Regards
Kevin
-
- Posts: 11
- Joined: Sat May 29, 2010 2:10 pm
-
- Posts: 3
- Joined: Mon May 05, 2014 11:58 am
Re: Jabiru engined Nipper, Throttle arrangement.
John
Yes I still have my project and am thinking about pushing it in front of the Waco project as it should only take 3-4 months to complete.
Yes I still have my project and am thinking about pushing it in front of the Waco project as it should only take 3-4 months to complete.