Hi
I'm looking for advice on the best way to fit tubular ferrules into holes in steel plates, and suggestions for suitable tooling "punches/press tool design".
It's for the various fuselage etc fittings where the hard bracing "piano wire" is attached through holes in the plates etc on a Sopwith Snipe repro.
Any advice would be appreciated.
Cheer's
Bob.
TUBULAR FERRULES IN STEEL PLATES "TOOLING"?
Moderators: John Dean, Moderator
-
- Posts: 2
- Joined: Wed Sep 12, 2012 10:51 am
TUBULAR FERRULES IN STEEL PLATES "TOOLING"?
Robet Trickett
026721
026721
Re: TUBULAR FERRULES IN STEEL PLATES "TOOLING"?
If I understand your requirements - the Boredom Fighter uses "Bleriot" type ferrules - brake line/ Bundy steel tubing in short lengths, with each end swaged into a smooth bell shape using a vise and a pair of suitable small home made turned steel formers, housed in hefty ply guides. Not easy to describe and I was skeptical at first, but they seem to work very well.
Ian
Ian