Page 1 of 1
Matco brake seals
Posted: Fri Nov 04, 2011 10:23 pm
by Colin Thompson
Could anyone suggest where I might purchase seals for my matco brakes.
Posted: Sat Nov 05, 2011 12:08 am
by Sandy Hutton LAA372
You can get a whole box of assorted O-Rings in almost any motor factors for about £6. They come in standard sizes and are suitable for braking systems. If there's special seals required then Airworld or LAS.
Edit:- I'm guessing the part number range is MS28775-xxx. If you still want aircraft standard seals and the MS28775's aren't available, then any of the following series are good to use :- M83248/1-xxx, M83248/2-xxx, M83461/1-xxx. I can't remember if the AN6227 range follows the same sizing sequence but they were obsolescent years ago. That's not to say they're not useable!
Posted: Wed Nov 16, 2011 7:18 pm
by Sandy Hutton LAA372
So did you get organised with seals Colin?
Posted: Fri Dec 02, 2011 5:33 pm
by Dave Evans
Have you tried Matco direct? I dealt with them directly for my tailwheel parts and they were very helpful. They have part numbers on their website..
http://www.matcomfg.com/
Posted: Tue Dec 13, 2011 9:47 pm
by Colin Thompson
The turth is that I did not need to replace seals ,I was either pumping out the excess oil that I had put in ,or they seals had swollen and are now working
so I now have a permit and I am getting the hangof steering my Avid ,
so I now have a permit and I am getting the hangof steering my Avid ,